A chemically protective Electro-Static Discharge (ESD) boot with an integral steel toe cap and vulcanized rubber sole for superior slip resistance. Suitable for applications such as pharmaceutical electro-protective areas.
Green Hazmax chemically resistant compound shaft certified to EN 13832
Conforms to EN 943-1 (Chemical protective clothing) and certified to this standard as part of an appropriate Respirex gas tight suit
Meets the requirements of NFPA 1991 (Chemical Vapour protection)
For use in EPA areas conforming to EN 61340-5 (ESD 99.6 MΩ dry, 11.8 MΩ wet EN ISO 20345)
Black vulcanized rubber sole for maximum grip - 30% better than a conventional safety boot sole
Slip resistance performance twice that required by SATRA TM144 standards
Two to three times the wear resistance of conventional soles
Greater cut resistance than conventional soles
AntistaticThe electrical resistance of the boot falls between 100 kΩ and 1000 MΩ ensuring that any build up of static charge by the wearer will be conducted safely to earth.
Chemical ProtectionEN 13832-3:2006 Approval for footwear highly resistant to chemicals.
Cold InsulationThe thermal insulation properties of the boot ensure that the temperature decrease of a boot at 23oC when placed in a cold chamber at -17oC is less than 10oC after 30 minutes when measured at the upper surface of the insole. Boot Marking: CI
Electro Static DischargeThis boot is suitable for use in EPA areas conforming to EN 61340-5
Energy Absorbing HeelProvides a minimum of 20J cushioning at the heel, reducing the risk of fatigue or injury. Boot Marking: E
Fuel Oil ResistantThe outer sole is resistant to oil, ensuring the working life of the boot wont be compromised if used in oily environments. The test involves immersion in oil for 22 hours after which the sole is checked for excessive swelling, shrinkage or increased hardness. Boot Marking: FO
Hot ContactThe sole has been tested for contact with a hot metal surface at 300'C for 60 seconds. Boot Marking: HRO
S5 Category Safety BootComplies with the basic requirements for safety footwear in EN ISO 20345:2011 and additionally includes a closed set region, antistatic properties energy absorption of seat region, resistance to fuel oil penetration resistance and a cleated out-sole.
Slip Resistant SRCTested and approved for resistance to slip on a ceramic tile floor coated with a dilute soap solution of sodium lauryl sulphate (NaLS) [SRA] and Slip resistance on steel floor with glycerol [SRB]. The tests measure forward slip on the heel and with the boot flat to the floor. Boot Marking: SRC
Toecap & MidsoleEpoxy coated steel toecap fitted tested for 200J impact resistance and 15kN compression. Stainless steel penetration resistant midsole fitted with penetration resistance greater than or equal to 1100N Boot Marking: P