Dielectric Boots

An electrically insulating Class 2 dielectric boot with an integral steel toe cap and vulcanized rubber sole for superior slip resistance. The Workmaster™ Dielectric boot provides high voltage protection of up to 20kV over the complete boot for over 8 hours, and 35kV over the sole for 3 minutes. This high-voltage boot is suitable for use by electricians, utility engineers and live working up to 17kV.

  • Every boot tested to 20kV
  • Leakage current less than 5mA at 5kV
  • Blue vulcanized rubber sole for maximum grip - 30% better than a conventional safety boot sole
  • Slip resistance performance twice that required by SATRA TM144 standards
  • Two to three times the wear resistance of conventional soles
  • Greater cut resistance than conventional soles
  • Cold InsulationCold InsulationThe thermal insulation properties of the boot ensure that the temperature decrease of a boot at 23oC when placed in a cold chamber at -17oC is less than 10oC after 30 minutes when measured at the upper surface of the insole. Boot Marking: CI
  • Energy Absorbing HeelEnergy Absorbing HeelProvides a minimum of 20J cushioning at the heel, reducing the risk of fatigue or injury. Boot Marking: E
  • Fuel Oil ResistantFuel Oil ResistantThe outer sole is resistant to oil, ensuring the working life of the boot wont be compromised if used in oily environments. The test involves immersion in oil for 22 hours after which the sole is checked for excessive swelling, shrinkage or increased hardness. Boot Marking: FO
  • High VoltageHigh VoltageDielectric boots that comply with the EN50321 standard for electrically insulating footwear.
  • Hot ContactHot ContactThe sole has been tested for contact with a hot metal surface at 300'C for 60 seconds. Boot Marking: HRO
  • SB Category Safety BootSB Category Safety BootComplies with the basic requirements for safety footwear in EN ISO 20345:2011
  • Slip Resistant SRCSlip Resistant SRCTested and approved for resistance to slip on a ceramic tile floor coated with a dilute soap solution of sodium lauryl sulphate (NaLS) [SRA] and Slip resistance on steel floor with glycerol [SRB]. The tests measure forward slip on the heel and with the boot flat to the floor. Boot Marking: SRC
  • ToecapToecapEpoxy coated steel toecap fitted tested for 200J impact resistance and 15kN compression.

product-data-sheet.pnguser-instructions.pngce-certificate.png

Care:

  • Machine washable at up to 40℃
  • Shelf life of over 10 years

Certification:

  • Safety Footwear EN ISO 20345:2011 - SB E CI HRO SRC FO
  • Electrically Insulating Footwear EN 50321:2018 Class 2 AC
  • Dielectric Footwear ASTM F1117
  • Personal Protective EquipmentPPE DIR 89/686/EEC